login   |    register
 General Modeling
MISSION: Model Geek University - Assembly 101            


  MISSION:Model Geek University - Assembly 101
  START DATE:January 1st, 2007
  ENDS:March 31st, 2007
Award Ribbon
Upon completion of this campaign you will recieve this fine ribbon to decorate your profile page and act as a link back to this page.

MG 101
This campaign was all techniques for an OOTB build. Techniques covered research, preparation, and assembly.

Operational Overview
This class is a class/campaign that focuses on the basic assembly of a kit Out Of The Box (OOTB).
It will focus on the following aspects of kit prep and assembly
-Part Clean up
-Assembly part fit
-Assembly seam lines
-Assembly glue marks, gap filling
-Assembly Alignment
-General Presentation of an unpainted kit (paint job not finished sub-assemblies are acceptable with paint)

The Rules and Regs
The rules/guidelines are
1. Any kit
3. Any genre
4. Any scale
5. There will be weekly readings posted in the forums and you must read them and post comments with your input on the readings
6. You must post two photos of your work representing each item mentioned above. You must photo document your progress.

Contest Element
You can join this campaign with the same project/kit/build as another campaign on any of the other KitMaker Network sites or a new one. If you piggy back make sure you can still photo document you build.
This campaign is about technique(s).


Click to see their campaign info.